Moxa Technologies C360 Manual do Utilizador descarregar pdf (Página 12)

~6~

hapter 2

Hardware Installation

2.1 Installation of C360

Step 1: Choose a PC that has DOS system inside.

NOTE: No matter what OS used, user has to configure the C360

Control Board via IO-IRQ.EXE under DOS.

Step 2: Power off the PC.

Step 3: Install the C360 Control Board(s) into a 16-bit slot(s).

NOTE: If installing more than one C360 Control Boards, insert ONE

AT A TIME and configure it using the IO-IRQ.EXE

program before inserting the next board. Each C360

Control Board must have unique base I/O address and IRQ.

The C360 Control Board has the following default (factory) settings:

BASE I/O address : 300H

IRQ : 2/9

Interface : BNC (10BASE-2)

Check if any existing board has the same I/O address or IRQ. If so,

user must try to avoid the conflict by doing either one of the

following:

a. Unplug the conflicting board temporarily if possible. Then

restore the board after changing the I/O address or IRQ of C360.

b. Change or disable the existing board's I/O address or IRQ in

advance.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 54 55

Sem comentários

Moxa Technologies C360 Manual do Utilizador Página 12