Moxa Technologies VPort 351 Guia de Instalação

MOXA Industrial Video EncoderVPort 351 Series Quick Installation Guide Third Edition, May 2007Moxa Networking Co., Ltd. Tel: +886-2-8919-1230

— 9 —Mounting Dimensions Rear ViewSide View Front ViewWall Mounting Kit DlN-Rail Kit DlN-Rail Kit DlN-Rail105.00101057.7530.507.759.0000.5340.0030.0

— 10 —Wall Mounting (Optional) Follow the steps below to mount the VPort 351 on a wall or panel. STEP 1:Remove the aluminum DIN-Rail attachment plat

— 11 —You should also pay attention to the following: y Use separate paths to route wiring for power and devices. If power wiring and device wiring

— 12 —Wiring the Relay Output RELAY 1RELAY 2Normal OpenCommonNormal Close The VPor 351 has two sets of relay outputs, labeled RELAY 1 and RELAY 2, l

— 13 —You may then use a console terminal program, such as MOXA PComm Terminal Emulator, to access VPort 351’s console configuration utility. RJ45 (

— 14 —MDI Port Pinouts MDI-X Port Pinouts 8-pin RJ45 Pin Signal Pin Signal 1 Tx+ 1 Rx+ 2 Tx- 2 Rx- 3 Rx+ 3 Tx+ 6 Rx- 6 Tx- RJ45 (8-

— 15 —13245Pin Assignment PINRS-422/485 RS-2321 GND GND 2 R- --- 3 R+ RxD 4 T-\D- --- 5 T+\D+ TxD LED Indicators Several LED indicators ar

— 16 —On RS-232 or RS-485 signals are being transmitted PTZ GREEN Off RS-232 or RS-485 signals are not being transmitted or have not been detected

— 17 —Serial Port PTZ port 1 RS-232 or RS-422/485 Terminal Block connector; Max. speed of 115.2 Kbps Console port 1 RS-232 RJ45 port GPIO Digi

— 18 —MTBF 160,000 hours WARRANTY 5 years Alarm Features y Pre/Post alarm video recording (9 MB memory) y Video motion detection with sensitivity

— 1 —Overview The VPort 351 is a high performance, 1-channel industrial video encoder that provides up to full D1 (720 x 480) @ 30 FPS video perform

— 2 —y TCP, UDP, and HTTP network transmission modes y Allows simultaneous access of up to 10 clients y Set video quality to CBR (constant bit ra

— 3 —VPort 351 Panel Layout VPort 351Front Panel ViewVPort 351-M-SCFront Panel View1778131291016111518142121Top Panel ViewRear Panel View201919V1, V

— 4 —First-Time Installation and Configuration Before installing the VPort 351 video encoder, check to make sure that all items in the Package Check

— 5 —NOTE The PTZ control protocol is not standardized. To use a particular PTZ control protocol, the video server must support the driver for that

— 6 —2. When the search has finished, the Model Name, IP address, MAC address, Serial (i.e., serial number), and HTTP Port of the VPort will be lis

— 7 — NOTE For Windows XP SP2 or above operating systems, the ActiveX Control component will be blocked for system security reasons. In this case, t

— 8 —Step 9: Accessing VPort’s System Configuration Click on System Configuration to access the overview of the system configuration to change the c